actin binding is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-06-25. Where a claim depends on a specific study, the study is described rather than over-claimed.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
No major regulatory agency has approved TB-500 for therapeutic use, and it holds no pharmacopoeial monograph. The name appears on the World Anti-Doping Agency prohibited list within the class covering peptide hormones, growth factors, and related substances. Detection in doping control relies on mass spectrometric methods applied to urine, often after preparation steps that concentrate the analyte. Discussion of TB-500 therefore clusters in biochemistry, sports medicine, and anti-doping literature rather than in registered clinical trials.
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Literature and online discussion often conflate TB-500 with full-length thymosin beta-4, even though the two differ in size and are not interchangeable in analytical terms. The fragment is produced by solid-phase peptide synthesis, and the product is a defined seven-residue chain rather than a biological extract. Because the term is a trade-style label, two vendors may supply materials of the same nominal sequence but different counter-ion content, purity, or water content. Comparisons across studies are therefore difficult unless the exact sequence and purity are reported.
TB-500 is a research peptide whose sequence matches residues 17 to 23 of thymosin beta-4, a 43-residue protein present in most mammalian cells. The chain is seven amino acids long, written as LKKTETQ, and is normally supplied with an acetyl group on the N-terminus. Suppliers list it as a lyophilised powder under the code name TB-500, and the same sequence appears elsewhere in catalogues as the thymosin beta-4 actin-binding fragment. The label is commercial rather than systematic, so no single authority fixes exactly what TB-500 denotes.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
TB-500 is a synthetic seven-residue peptide whose sequence, LKKTETQ, matches the N-terminal actin-binding region of thymosin beta-4. It is usually supplied in an N-terminally acetylated form, a modification that blocks the free amino terminus and can influence behavior in solution. In the research literature the same sequence appears under several names, including thymosin beta-4 fragment and shortened thymosin beta-4. Because it is a short peptide rather than the full 43-residue parent protein, its measured properties differ from those reported for thymosin beta-4 as a whole, and the two are not interchangeable in experimental design.
Thymosin beta-4 itself is a small, widely expressed protein that sequesters monomeric actin and participates in cell migration, angiogenesis, and tissue repair. Researchers have examined the shortened fragment as a possible mimic of some of these activities, reasoning that the actin-binding motif lies within the first few residues. Binding to monomeric actin has been observed in cell-free systems. Whether the fragment reproduces the broader effects of the full protein in living tissue remains an open question, and findings from animal models are frequently cited without a clear bridge to human physiology.
== Applications == Depending on the column size, CIM monolithic columns are primarily used for the purification or analysis of large biomolecules which are being used for cancer gene therapy, treatment of viral infectious diseases and treatment of genetic diseases. Some types of molecules that can be successfully purified using CIM columns are pDNA, IgM, inter-alpha inhibitors, virus like particles, and diverse viruses; adenoviruses, bacteriophages, feline calicivirus, hepatitis A, lentivirus, influenza A and B, rabies virus, rotavirus, tomato and pepino mosaic virus.
=== Simulated chemical pathways === In 2020, chemists described possible chemical pathways from nonliving prebiotic chemicals to complex biochemicals that could give rise to living organisms, based on a new computer program named AllChemy.
== General references == Acheson, D. J. (1990), Elementary Fluid Dynamics, Oxford Applied Mathematics and Computing Science Series, Oxford University Press, ISBN 978-0-19-859679-0 Batchelor, G. K. (1967), An Introduction to Fluid Dynamics, Cambridge University Press, ISBN 978-0-521-66396-0 Currie, I. G. (1974), Fundamental Mechanics of Fluids, McGraw-Hill, ISBN 978-0-07-015000-3 V. Girault and P. A. Raviart. Finite Element Methods for Navier–Stokes Equations: Theory and Algorithms. Springer Series in Computational Mathematics. Springer-Verlag, 1986 Landau, L. D.; Lifshitz, E. M. (1987), Fluid mechanics, vol. Course of Theoretical Physics Volume 6 (2nd revised ed.), Pergamon Press, ISBN 978-0-08-033932-0, OCLC 15017127 Polyanin, A. D.; Kutepov, A. M.; Vyazmin, A. V.; Kazenin, D. A. (2002), Hydrodynamics, Mass and Heat Transfer in Chemical Engineering, Taylor & Francis, London, ISBN 978-0-415-27237-7 Rhyming, Inge L. (1991), Dynamique des fluides, Presses polytechniques et universitaires romandes Smits, Alexander J. (2014), A Physical Introduction to Fluid Mechanics, Wiley, ISBN 0-47-1253499 Temam, Roger (1984): Navier–Stokes Equations: Theory and Numerical Analysis, ACM Chelsea Publishing, ISBN 978-0-8218-2737-6 Milne-Thomson, L.M., C.B.E (1962), Theoretical Hydrodynamics, Macmillan & Company Limited Tartar, L (2006), An Introduction to Navier Stokes Equation and Oceanography, Springer ISBN 3-540-35743-2 Birkhoff, Garrett (1960), Hydrodynamics, Princeton University Press Campos, D.
== Types of human remains in museums == Museum collections contain human remains in diverse forms, including entire preserved bodies, discrete parts of the anatomy, and even art and artifacts created out of human body parts.
Sources: en.wikipedia.org
== Function == Cavin-2 is required for blood vessel formation (angiogenesis) in humans and zebrafish and required also for the endothelial cell proliferation, migration and invasion in humans. Cavin-2 plays an important role in endothelial cell maintenance by regulating eNOS activity. Cavin-2 controls the generation of nitric oxide (NO) in human endothelial cells by controlling the activity and stability of the protein endothelial nitric-oxide synthase (eNOS).
== Pharmacology == Eugenol and thymol possess general anesthetic properties. Like many other anesthetic agents, these 2-alkyl(oxy)phenols act as positive allosteric modulators of the GABAA receptor. Although eugenol and thymol are too toxic and not potent enough to be used clinically, these findings led to the development of 2-substituted phenol anesthetic drugs, including propanidid (later withdrawn) and the widely used propofol. Eugenol and the structurally similar myristicin have the common property of inhibiting MAO-A and MAO-B in vitro. In humans, complete excretion occurs within 24 hours and metabolites are mostly conjugates of eugenol.
== Reaction == The Staphylococcus aureus sortase is a transpeptidase that attaches surface proteins to the cell wall; it cleaves between the Gly and Thr of the LPXTG motif and catalyses the formation of an amide bond between the carboxyl-group of threonine and the amino-group of the cell-wall peptidoglycan.
Generally, metals are shiny and dense. They usually have high melting and boiling points due to the strength of the metallic bond, and are often malleable and ductile (easily stretched and shaped) because the atoms can move relative to each other without breaking the metallic bond. They conduct electricity because their electrons are free to move in all three dimensions. Similarly, they conduct heat, which is transferred by the electrons as extra kinetic energy: they move faster. These properties persist in the liquid state, as although the crystal structure is destroyed on melting, the atoms still touch and the metallic bond persists, though it is weakened. Metals tend to be reactive towards nonmetals. Some exceptions can be found to these generalizations: for example, beryllium, chromium, manganese, antimony, bismuth, and uranium are brittle (not an exhaustive list); chromium is extremely hard; gallium, rubidium, caesium, and mercury are liquid at or close to room temperature; and noble metals such as gold are chemically very inert. Nonmetals exhibit different properties. Those forming giant covalent crystals exhibit high melting and boiling points, as it takes considerable energy to overcome the strong covalent bonds. Those forming discrete molecules are held together mostly by dispersion forces, which are more easily overcome; thus they tend to have lower melting and boiling points, and many are liquids or gases at room temperature. Nonmetals are often dull-looking.
==== Expressive therapies ==== Expressive therapies or creative arts therapies are a form of psychotherapy that involves the arts or artmaking. These therapies include art therapy, music therapy, drama therapy, dance therapy, and poetry therapy. It has been proven that music therapy is an effective way of helping people with a mental health disorder. Drama therapy is approved by NICE for the treatment of psychosis.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Desiccated storage at −20 °C is conventional, with −80 °C for extended periods. Vials should be warmed to room temperature before opening to prevent condensation on the powder.