A practical reference on TB-500: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-01-11 and is reviewed periodically as new material appears.
Discussion of TB-500 appears in several distinct literatures that rarely cite one another. Peer-reviewed studies usually describe in vitro assays or small animal experiments and are cautious about extrapolation. Veterinary and sports communities circulate anecdotal reports with limited methodological detail. Commercial listings add a third layer, often using the name interchangeably with thymosin beta-4 even though the two molecules differ in size and sequence. Regulatory status varies by country, and the compound is not a licensed medicine in most jurisdictions, so readers comparing sources should check which molecule and which purity each source actually describes.
TB-500 is a synthetic seven-residue peptide whose sequence, LKKTETQ, matches the N-terminal actin-binding region of thymosin beta-4. It is usually supplied in an N-terminally acetylated form, a modification that blocks the free amino terminus and can influence behavior in solution. In the research literature the same sequence appears under several names, including thymosin beta-4 fragment and shortened thymosin beta-4. Because it is a short peptide rather than the full 43-residue parent protein, its measured properties differ from those reported for thymosin beta-4 as a whole, and the two are not interchangeable in experimental design.
Thymosin beta-4 itself is a small, widely expressed protein that sequesters monomeric actin and participates in cell migration, angiogenesis, and tissue repair. Researchers have examined the shortened fragment as a possible mimic of some of these activities, reasoning that the actin-binding motif lies within the first few residues. Binding to monomeric actin has been observed in cell-free systems. Whether the fragment reproduces the broader effects of the full protein in living tissue remains an open question, and findings from animal models are frequently cited without a clear bridge to human physiology.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
| Property | Value | Notes |
|---|---|---|
| Molecular class | Synthetic peptide | N-terminal fragment of thymosin beta-4 |
| Residue count | Seven | Sequence LKKTETQ |
| Approximate mass | 889 Da | Acetylated seven-residue peptide |
| Common synonyms | TB4 fragment, TB500 | Not identical to full-length TB4 |
| Reported activity | Actin binding | Observed mainly in cell-free systems |
Detection in biological samples relies on mass spectrometry, typically liquid chromatography coupled to tandem mass spectrometry after peptide extraction and enrichment. Intact peptides can also be confirmed by high-resolution mass measurement together with fragmentation data. Detection windows in urine are short because the peptide is degraded by proteases and cleared quickly, and concentrations are low. Many jurisdictions treat the compound as a prohibited substance in sport, grouped with peptide hormones and related factors, while it is not an approved therapeutic product. Identity and purity statements therefore rest on certificates of analysis, ideally issued by an independent laboratory.
Material is normally supplied as a lyophilised powder in a sealed vial. The powder is hygroscopic, so exposure to humid air leads to water uptake, caking and gradual loss of the fluffy texture that indicates a good freeze-dry. Vials are best kept sealed with desiccant, protected from light and stored cold. Letting a cold vial warm to room temperature before opening reduces condensation on the contents. Purity is normally reported from a chromatographic run, and that figure applies to the batch as tested rather than to the vial after repeated opening.
Once dissolved, the peptide is far less stable than the dry powder. Aqueous solutions are subject to hydrolysis, oxidation at susceptible residues and gradual loss of material through adsorption onto glass and plastic surfaces. Terminal glutamine can cyclise under some conditions, producing a related species that complicates purity assessment. Dilute solutions tend to lose a larger fraction of material to surfaces than concentrated ones. Buffers, pH and ionic strength all influence the rate of change, so stability figures are only meaningful when those parameters are stated alongside the storage interval.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Material sold under this label typically arrives as a freeze-dried powder in a sealed vial with a certificate of analysis. Such certificates usually report reversed-phase chromatography purity plus a mass confirmation, and stated purities commonly sit between 95 and 99 percent. Counter-ion identity, residual trifluoroacetate, water content, and peptide net weight are separate specifications that a certificate may or may not include. A purity figure alone does not establish sequence identity, so independent mass verification remains the practical check.
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
=== Atomic radius === Historically, the physical size of atoms was unknown until the early 20th century. The first calculated estimate of the atomic radius of hydrogen was published by physicist Arthur Haas in 1910 to within an order of magnitude (a factor of 10) of the accepted value, the Bohr radius (~0.529 Å). In his model, Haas used a single-electron configuration based on the classical atomic model proposed by J. J. Thomson in 1904, often called the plum-pudding model. Atomic radii (the size of atoms) are dependent on the sizes of their outermost orbitals. They generally decrease going left to right along the main-group elements, because the nuclear charge increases but the outer electrons are still in the same shell. However, going down a column, the radii generally increase, because the outermost electrons are in higher shells that are thus further away from the nucleus. The first row of each block is abnormally small, due to an effect called kainosymmetry or primogenic repulsion: the 1s, 2p, 3d, and 4f subshells have no inner analogues. For example, the 2p orbitals do not experience strong repulsion from the 1s and 2s orbitals, which have quite different angular charge distributions, and hence are not very large; but the 3p orbitals experience strong repulsion from the 2p orbitals, which have similar angular charge distributions. Thus higher s-, p-, d-, and f-subshells experience strong repulsion from their inner analogues, which have approximately the same angular distribution of charge, and must expand to avoid this.
==== Train ==== Amtrak, the national passenger rail system, provides service to Albany from its Albany Station at 10th Avenue SW on two routes. Long-haul train route the Coast Starlight (with service from Los Angeles to Seattle) stops in Albany daily in both directions. Amtrak Cascades commuter trains operate between Vancouver, British Columbia and Eugene, Oregon, and serve Albany several times daily in each direction. The Amtrak Cascades line is the proposed path of the Pacific Northwest Corridor high-speed rail line. The Albany station would be one of many stops along the proposed 466-mile (750 km), 110-mile-per-hour (180 km/h) passenger line. The station itself was constructed in 1909 for the Southern Pacific Railroad and is built of masonry. It is one of the oldest continuously operating passenger rail stations in the U.S. and has one of the best-equipped engine shops in the northwest. Southern Pacific 4449, a steam locomotive which resides at the Oregon Rail Heritage Center in Portland, occasionally visited the shop for repairs when it was residing at the Brooklyn Roundhouse in Portland (before 2012), as did several other locomotives stored at the now-demolished roundhouse. Beginning in 2004, the station and the surrounding area underwent an $11.3 million restoration that was funded with a combination of federal, state, local, and Amtrak money. In 2006 the city received the Award in Downtown Excellence from the Oregon Downtown Development Association for the renovation of the station.
Injector pens are an alternative to the manufacture of medication for injection in vials containing either liquid or a powder to which a diluent such as sterile water is added. When a vial is used as a means of storage, the end-user must use a syringe to "draw up" or remove the medication from the vial to prepare it for administration. The end user must then perform a series of actions to insert the needle of the syringe under the skin, and depress the plunger on the syringe to inject the dose. This requires dexterity which may make it difficult to accurately or completely administer the appropriate doses of medications. Injector pens remove some of the complications of syringes by allowing the pen to be "pushed" against the skin at a 90-degree angle (removing the need to inject at a proper angle as is the case with syringes), as well as by replacing a long, thin plunger of a syringe with a simple button which is depressed and held to inject the dose.
Meldal's innovation became the paradigmatic reaction of Click Chemistry. One set of particularly significant reports regarding azide couplings came from the Bertozzi lab who conducted the reaction within living cells. In 2022, the Nobel Prize in Chemistry was jointly awarded to Carolyn R. Bertozzi, Morten P. Meldal, and Karl Barry Sharpless, "for the development of click chemistry and bioorthogonal chemistry".
Apart from the failed Third Period policy in the early 1930s, Marxist–Leninists played an important role in anti-fascist resistance movements, with the Soviet Union contributing to the Allied victory in World War II. In accordance with the three-power Yalta Agreement (4–11 February 1945), the Soviet Union purged native fascist collaborators and these in collaboration with the Axis Powers from the Eastern European countries occupied by the Axis Powers and installed native Marxist–Leninist governments.
Sources: en.wikipedia.org
== Gene == The luteinizing hormone beta subunit is encoded by a single gene in all mammals. In primates, this gene is located within a cluster that arose through gene duplication, and also includes multiple redundant genes encoding the beta subunit of chorionic gonadotropin as well as several nonfunctional pseudogenes. In humans these are contiguous on chromosome 19q13.3. In equids the beta subunit polypeptides of luteinizing hormone and chorionic gonadotropin are identical in sequence, differing only in their carbohydrate side-chains, and are the product of a single gene.
== Medical uses == Vardenafil's indications and contraindications are the same as with other PDE5 inhibitors; it is closely related in function to sildenafil citrate (Viagra) and tadalafil (Cialis). The difference between the vardenafil molecule and sildenafil citrate is a nitrogen atom's position and the change of sildenafil's piperazine ring methyl group to an ethyl group. Tadalafil is structurally different from both sildenafil and vardenafil. Vardenafil's relatively short effective time is comparable to but somewhat longer than sildenafil's. Despite the structural differences between vardenafil and sildenafil, they both show similar ocular side effects due to their similar selectivity overlap with PDE6, an enzyme found in the eye. Beyond its indications for erectile dysfunction, vardenafil may be effective in the treatment of premature ejaculation, where it may significantly increase the time from penetration to ejaculation.
== In newborns == Acrocyanosis is common initially after delivery in preterm and full term newborns. Intervention is typically not required as it is seen as a normal finding. Acrocyanosis can also return in a newborn if a baby is cold, such as after a bath, and is considered normal as well.
== Chemistry == Lercanidipine is used in form of the hydrochloride, which is a slightly yellow crystalline powder and melts at 197 to 201 °C (387 to 394 °F) in crystal form I or 207 to 211 °C (405 to 412 °F) in crystal form II. It is readily soluble in chloroform and methanol, but practically insoluble in water. This high lipophilicity (compared to older dihydropyridines) is intentional because it causes the substance to bind to lipid membranes, allowing for a longer duration of action. The lercanidipine molecule has one asymmetric carbon atom. While the S-enantiomer is more effective than the R-enantiomer, marketed formulations contain a 1:1 mixture of both (i.e., the racemate).
Cider ( SY-dər) is an alcoholic beverage made from the fermented juice of apples. The juice of most varieties of apple (including crab apples) can be used to make cider, but cider apples are most desirable. The addition of sugar or extra fruit before a second fermentation increases the ethanol content of the resulting beverage. Cider is widely available in Britain, particularly in the West Country, and Ireland. Together they have the world's highest per capita consumption, as well as the largest cider-producing companies. Ciders from the South West of England are generally higher in alcoholic content. Cider remains traditionally popular across the Anglosphere, such as India, South Africa, Canada, Australia, New Zealand, Hong Kong, and the United States (particularly in New England and the Midwest).
Sources: en.wikipedia.org
No. Thymosin beta-4 is a 43-residue protein, while TB-500 refers to a seven-residue fragment corresponding to its N-terminal region. The two names are often used loosely in commercial and community writing, which obscures the difference in size, sequence, and likely behavior.
The fragment contains an actin-binding motif, and cell-free experiments show that it can interact with monomeric actin. That observation is the basis for interest in cell migration and repair processes. Effects reported in animals are not established for humans.
Purity is usually stated by the supplier rather than fixed by a pharmacopoeial monograph, and typical listings report a percentage from reverse-phase HPLC. Independent verification is uncommon. Because no single accepted specification exists, comparisons between lots and between suppliers are difficult.
Divide it into single-use aliquots and hold them frozen at -20 °C or below, protected from light. Repeated thawing of one container is the main avoidable source of variability.